2 Wire Maser/Slave - The Diamond board uses a unique Master/Slave system that requires only two wires.

Motor Brake - If the on position is selected electric gate opener, the gate will stop instantly when it reaches the limit switches. This is essential on uphill/downhill applications and on all Fail Safe operations.

One Pass - This tailgating feature works with the reverse loop to allow only one car to pass. After the car passes the gate closes instantly, if a second car approaches the gate stops, and resumes closing once the car has left.

Stop-Reverse - This radio feature allows the transmitter to work as a three-button station and is useful for partial opening. The first command of the electric gate opener opens the gate, the second stops the gate, and the third command will close the gate.

Timer - The adjustable timer can be set from 1 to 60 seconds, with a maximum run time of 60 seconds.

Overload - If the motor reaches the stall amp for 3 seconds, it will automatically shut down.

Receiver - The receiver terminal is mounted on the control box for easy installation and is pre-wired for a 3-wire or 4-wire receiver.

Stainless Steel Access Door - Eagle offers a full access to the control board through the locking stainless steel door on its electric gate openers.

ERD - If the gate hits an obstruction while closing, it will re-open. If it hits an obstruction while opening, it will stop, reverse 6 inches and stop again. The sensitivity is adjustable separately for the open and close cycles.

Global Inputs - The Diamond board's Global Inputs include key switch, keypad, exit loop, phantom loop, reverse loop, edge sensor, open, stop, and close.

Outputs - Outputs include on board 24 VDC for MAG Lock, alarm, and 24 VAC auxiliary power.

Safety Alarm - If the gate hits an object twice while closing or opening, the electric gate opener will shut down for 5 minutes. On the Diamond board you have two options for reset mode. Selecting the off position will require a manual reset of the board if the previous happens. However, by selecting the on position, the system will automatically reset itself.

120 VAC Power Outlets - The operator contains two 120 VAC Power Outlets for the users convenience.

Power on/off Switch - The operator has an easily accessible power disconnect switch that allows for easy installation and service.

No Pinch Arm - This safety features prohibits the arm from extending past the operator's body when the arm is in the fully extended position.

Gate Opening - Can operate to either the left or right side.