|
|
The Mighty
Mule® (FM350) will handle gates up to 16 ft. long or up
to 550 lbs.
• Easy to install one piece low-voltage system
• No electrician required.
• Solar Compatible.
• Up to 1500 cycles per day, with battery back up. |
• One single gate
opener
• One Entry Transmitter
• Installation hardware
• Battery harness
• Receiver
• Installation manual
• Plug-in Transformer
• Installation video
• Warning signs (2)
• 12 month limited warranty
|
No Battery Included |
| The Mighty Mule® 350
E-Z Gate Opener is designed for installation on a pull-to-open
single leaf gate (gates that open into the property). By purchasing
an accessory bracket (FM148), the Mighty Mule® E-Z Gate
Opener can accommodate a push-to-open single leaf gate (gates
that open out from the property). The gate must not exceed
8 feet and 550 pounds or exceed 16 feet and 150 pounds . The
Mighty Mule® E-Z Gate Opener can be used on vinyl, aluminum,
chain link, farm tube, and wrought iron gates. Use on solid
(wood) gates is not recommended. Solid surface gates have
a high resistance to the wind. If the wind is strong enough,
the opener will obstruct and stop. |
|
The Mighty Mule® E-Z Gate Opener features
adjustable obstruction sensing. This safety feature makes
the gate stop and reverse direction within 2 seconds when
it comes in contact with an obstruction. MIN is the factory
setting; meaning the gate will exert the minimum force on
an obstruction before it stops and reverses direction.
The Mighty Mule® E-Z Gate Opener also
has an adjustable auto-close feature. After the gate reaches
the fully open position, it can be set to remain open up
to 120 seconds before automatically closing. Pressing the
transmitter button at any time after the gate opens fully
will cause it to close immediately. OFF is the factory setting;
meaning the gate will stay open until you press the transmitter
(or keypad, etc.) again.
|
|
DRIVE
• Low friction screw drive (linear actuator) rated
for -5 ºF to +160 ºF (-28 ºC to +71 ºC).
• Powered by a 12 V motor with integral case hardened
steel gear reducer. Motor speed reduced to 260 rpm. Generates
520 inch lb. of torque at 12 V.
• Maximum opening arc of 110º. Approximate opening
time (90º): 18 seconds, depending on weight of gate.
POWER
• The system is powered by a 12 Vdc automotive or marine
battery.
• Battery charge is maintained by a 120 Vac, 18 Vac
output transformer [rectified to 14.5 Vdc (40 VA) through
the
GTO control board] or by optional GTO Solar Panels [the
panel should generate minimum of 5 W at 300 mA]. A
diode on the control board prevents battery discharge.
IMPORTANT: Never use both transformer and solar panel -
this will damage the battery and control board.
• One (1) blade-style control board fuse is rated for
15 A.
NOTE: The transformer should not be directly connected to
any battery. Do not replace fuses
with higher ampere rated fuses; doing so will void your
warranty and may damage your control board.
CONTROL
• GTO microprocessor-based control board is set for
single leaf, pull-to-open gate installations. DIP switches
can be
adjusted to accommodate an optional kit for push-to-open
gates (see Accessory Catalog).
• Control board has temperature compensated circuits.
• A circuit on the control board regulates charging.
"Sleep draw" is 25 mA; "active draw"
is 2 to 5 A.
• Auto-memorization of digital transmitter code.
• GTO remote-mounted RF receiver tuned to 318 MHz.
• Opener length with push-pull tube fully retracted
is 371/4", mounting point to mounting point.
• Adjustable auto-close timer (OFF to 120 s), and obstruction
sensitivity.
• Power terminal block accommodates a transformer or
solar panels.
• DIP switches simplify setup of gate opener.
• Accessory terminal block fully compatible with all
Mighty Mule access controls.
• Control board allows connection of safety edge sensors
and photoelectric sensors.
• Audio entrapment alarm sounds if unit encounters
an obstruction twice while opening or closing.
OPERATIONAL CAPACITY
• The Gate Capacity Chart shows approximate cycles,
per day, you can expect from the Mighty Mule 350 Automatic
Gate Opener when powered with a transformer. Actual cycles
may vary slightly depending upon the type and condition
of gate and installation.
|
|
Description
|
List Price
|
Your Price
|
Buy Now
|
|
Mighty
Mule 350 Gate Opener
|
$475.00
|
$395.00 |
|
|
Description
|
List
Price
|
Your
Price
|
Buy
Now
|
|
|
|
$35.40
|
$22.49
|
|
|
|
|
$47.86
|
$39.00
|
|
|
|
|
$104.27
|
$69.00
|
|
|
|
|
$215.65
|
$150.00
|
|
|
|
|
$208.42
|
$129.00
|
|
|
|
|
$35.45
|
$14.75
|
|
Call
us with further questions we are pleased to serve you.
(800) 878-7829
Our business is "Automatic gate operators" .
|
Discount
Fence Supply, Inc.
endeavors to bring you the most up-to-date products, specifications,
availability, as well as prices. Pricing, availability,
and specifications are subject to change without any notice.
Discount Fence brings you quality Aluminum fencing from
Delgard,
Jerith,
and Elite.
Discount Fence Supply,
Inc. desires to be the best
automatic gate opener
supplier on the Internet, from GTO/PRO
to Eagle
Gate Openers. Our goal not only provides the
best product for job but also the best customer
service. We not only sell gate
operators but we also sell a full line of Security
Access systems. Check out our full line of Keypad
and Telephone
Entry devices from Linear,
American
Access, and also DoorKing.
We don't stop there but we offer a full like of Gate
protection device, for example we offer Miller
gate edges, and photocells,
For the more suffocated application we have computer controlled
proximity
card readers. Remember to protect your new electronics
with the surge
protector that will guarantee your your product longer
lasting value to your fence and gate
project.
|
|
